Simple/Basic Motor Pairing

Modified on Tue, 21 Aug, 2018 at 9:23 AM

Shade will jog when connected to power source – the shade will jog again in approximately 3-10 seconds, this confirms that your remote is paired to the shade. The control will now operate the shade.


If the shade jogs two times (x2) when powered up- this confirms that the remote is not paired to the shade. Follow these steps to pair the remote to the shade:


To pair the controller with the shade- immediately after connecting to power press and release the programming button ~less than 2 seconds the shade will jog to confirm pairing. The control will now operate the shade.

If you do not get a shade jog, follow these steps:

Disconnect the power- at least 2 minutes. Then connect power to the shade, the shade will jog.  Press and release the control programming button ~less than 2 seconds. The control will now operate the shade.




Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article