How do I Group the shades on the Ysia remote?

The steps below are for copying shades that are on individual channels on the remote and creating a group channel.

Step 1: Using the channel selector button on the remote, put the remote on the channel that currently controls the shade as an individual channel.

Step 2: Ensure the remote is within 2 feet of the motor head. Press and hold the programming button on the back of the remote until the LED at the top of the remote goes green > red> green and release. Wait for the motor to jog. This may not happen immediately. Wait for the motor to jog before pressing any other buttons on the remote.

Step 3: Put the remote on the channel that is intended to be the group channel.

Step 4: Ensure the remote is still within 2 feet of the motor head. Briefly press the programming button on the back of the remote for less than a half second. The LED on the top of the remote should flash orange and then green. Wait for the motor to jog. Once the motor jogs, it has been copied to the group channel.

 Step 5. Repeat steps 1-4 for any other shades that are to be on the group channel.